My first visit to Perfect touch.

Just been reading about yellow coupe's day out, really bad luck mate.
I found the guys at pefect touch spot on, being quite new to tuning i wasn't sure what to expect.
Must say my arse was twiching away everytime i could hear my baby being put through her paces.
A couple of hours later and i was told 340bhp @300lbs - well happy.
Would defiantly go there again.

Mods are - GT28RSR - EVO 8 FMIC - Aquamist - Staight Induction Mod - 3" exhaust from the turbo back with decat -HKS BOV - standard internals.

Any graphs?

Ross

Hi Ross,
Yeah got the graph - will post up soon.
See your one of Barbz's customers to, he's the man - did all my work as well.

Did ya get headwork from him? 340bhp is higher than most on rsr.

Ross

340 bhp and 300 lb/ft (407 Nm) is really good

Did you measure the inlet temp (after IC) during the session? Does PT use a big fan?
Max boost pressure?

No internal work - boost was set at 1.4 bar which is probably why the bhp figure is a bit higher than most.

Didn't measured the inlet temps - had a quick look round before they started mapping, looked like the fans were under the front of the car ( in the floor ) - but i couldn't be sure.
Wasn't aloud in there during mapping.