Removing the Pininfarina emblem,dashboard

Hello! Now i have loosen all the screws at the dashboard! But it seems like it´s just stuck in the middle now! So at each side on the pininfarina emblem should be a screw? But i don´t dare to pull it harder,

Any ideas of getting it loose?

Greetz/Emil

im sure someone said recently that its just stuck in and that there is a screw behind it holding the dash strip on

paul

The badge is held at each end by a clip. Once the badge is removed there is a hole through which you have to undo an allen bolt 5mm IIRC.

Removing the badge is a complete pain. Best method is to buy the right tool (a badge puller)
Failing this get and old credit card and slid it under the bagde and use this to pull the badge away. Packing tape also works evidently.

DO NOT think of using anything to lever the badge off as you will dent the metal strip.

John

they can be so so tight agree with bockers. easy to damage the strip. If you do get it out, clean up the roll pin clip things, adn prise them open a little so it is easier to remove another time