Posted By: Serg1
3D Printing - 07/06/2018 11:14
Anyone out there in this type of business or recommend a company.
3D Printing
Posted By: Anonymous
Re: 3D Printing - 07/06/2018 18:06
What is it that you need doing?
Recommendations depend on quality/volume/material and whether you need the CAD work doing.
Recommendations depend on quality/volume/material and whether you need the CAD work doing.
Posted By: Serg1
Re: 3D Printing - 07/06/2018 19:25
I have a very good quality photograph taken of a military oval shako plate. Plate size 92 x 68mm, I need to get this made up as a 3D plate in brass as thin as possible.
Posted By: Anonymous
Re: 3D Printing - 07/06/2018 19:35
Are you able to link the picture and I may be able to give you some advice. I do basic CAD work and also do 3d printing.
Clearly someone far better than I would be the choice for getting this done but I may be able to help initially.
On the plus side, a printer can do brass and can do layer heights less than 0.01 if needed!
Clearly someone far better than I would be the choice for getting this done but I may be able to help initially.
On the plus side, a printer can do brass and can do layer heights less than 0.01 if needed!
Posted By: Serg1
Re: 3D Printing - 07/06/2018 20:07
PM sent.
Posted By: jonnyboy54321
Re: 3D Printing - 07/06/2018 21:09
quite intriguing this thread!
Posted By: Begbie
Re: 3D Printing - 08/06/2018 09:39
Posted By: Anonymous
Re: 3D Printing - 08/06/2018 10:09
I'm intruiged by Begbies emoji. Is there a CAD master in the house?
Posted By: Begbie
Re: 3D Printing - 11/06/2018 06:48
Originally Posted By pfoe
I'm intruiged by Begbies emoji. Is there a CAD master in the house?
Sorry, put the reply in the wrong thread as you did another thread about being back on here
Not a CAD master, just a DBA