Posted By: Danhgt
Dan 's 16v Turbo discussion thread - 05/06/2009 12:28
I should of scrapped it and brought a decent one to start with
Posted By: Begbie
Re: Dan 's 16v Turbo discussion thread - 05/06/2009 12:45
Glad to see my old engine came back to life in the end
Posted By: Danhgt
Re: Dan 's 16v Turbo discussion thread - 05/06/2009 12:52
Yeah, apart from that cylinder it was in really good condition.
Posted By: Anonymous
Re: Dan 's 16v Turbo discussion thread - 14/06/2009 08:35
i like reading your restoration thread!!!
are you going to change the tank hangers for new ones as these can fail if i'm not mistaken, might as well while it's off
Posted By: Danhgt
Re: Dan 's 16v Turbo discussion thread - 14/06/2009 17:22
I did'nt realise they could snap, I probaly will change them if there bad.
Posted By: Anonymous
Re: Dan 's 16v Turbo discussion thread - 14/06/2009 18:11
i think they rust through by the bolt holes
Posted By: kj16v
Re: Dan 's 16v Turbo discussion thread - 14/06/2009 22:37
Great work, mate. Well done.
Posted By: Danhgt
Re: Dan 's 16v Turbo discussion thread - 15/06/2009 00:42
Cheers.
I'll have a close look at them (once i've got the rust off them)
Posted By: kj16v
Re: Dan 's 16v Turbo discussion thread - 15/06/2009 18:53
BTW. I put up a post recently asking how people managed to remove 16VT engines from underneath. How did you do it?
Posted By: Danhgt
Re: Dan 's 16v Turbo discussion thread - 15/06/2009 20:03
Out the bottom, the whole lot in one.
Posted By: kj16v
Re: Dan 's 16v Turbo discussion thread - 15/06/2009 21:46
How did you lift the car up?
Posted By: Danhgt
Re: Dan 's 16v Turbo discussion thread - 15/06/2009 22:29
With the hoist, I put the car up on logs once i'd lowered the engine to the floor.