So, im changing an old 2 tap sink to a monobloxk mixer,my issue is as follows:
The plastic pipework in my house is all 10mm. This 10mm pipe goes to an isolator for hot and one for cold under the sink.
This isolator has got a female coupling on the to mate with the existing taps.
The tails I have for my monoblock (and seemingly all I'm able to buy) are female.
How do I go about connecting the female isolator to the female tails?
If it wasn't 10mm pipe I could in theory just change various plastic push fit components but the resources just aren't out there!
Back in a super powered Sprinty