Hello everyone, I wanted to know if anyone knows or has installed these adjustable suspension of Ta Tecnix, they are very cheap I hope they are not bad, someone could explain how to install them?What I would like to know is: do you have to remove the rubber top mount bearing? And attach it directly to the top mount plates?
Too late, I've already installed it. Anyway I asked the company, ta technix, and they replied that it's OK for the 20VT. The corresponding axle load, Even the numbers in the booklet are ok. They seem to work well until now, I'll wait until Tuesday for the tire to make me converge and then we'll see how fast it works, I'll let you know.
Good. you can adjust how you like it. The steering has become much lighter, and the kickbacks have waned a lot. Consider that I had mounted the Monroe + hoermann and the car was as hard as wood, especially with the 17-inch wheels. Now you're much better. I will wait for tomorrow to adjust the tire convergence and then I will do some tests on the highway.
Hello to all. I wanted to give some information about the suspensions. Today I had the chance to try the car on the highway about 240 km. the car behaves very well, even on the curves. Obviously it's not a high-end asset, but it does its job well. For those wishing to install it, I warn you that this is a pretty tough setup, especially for those who switch from an original to this. Another thing, if you install it, I highly recommend to grease all the moving parts that are in contact with each other, to avoid hearing noises when turning from a stationary position. thank you.