Its too big for the 15mm connectors on the catch tank, so I used a short piece of the see-through hose to sleeve the catch tank connector up to 16mm. Also, the 16mm bore is smaller than the 19-20mm of the breather hose, so one of the blue connectors needs to be a 19mm -> 16mm reducer
Blue hose connectors (straight or reducer) are from Halfrauds
A couple of questions as it looks like I need to do this mod.. I'm not 100% sure as to whether quoted sizes are for a SIP, or standard intake (assuming there is a difference??)...
- What size oil breather filter do I need to connect to pipe 4? (this is the more important bit) - What size blanking plug do I need to block off the hole on a standard turbo intake pipe? (25mm I think)
Cheers!
Tim.
Last edited by TimC; 13/05/201009:16. Reason: Clarity
I can help with the less important bit, to block the turbo side I used a bung which was a reducer 30mm -> 25mm. Sorry I can't remember about the pipe 4 side, as it was ages ago I did this.
I can help with the less important bit, to block the turbo side I used a bung which was a reducer 30mm -> 25mm. Sorry I can't remember about the pipe 4 side, as it was ages ago I did this.
Just been cleaning my bailey this weekend and noticed that the item blocking my hole it none other than a spark plug