Hi i"ve just recieved some Fender side-skirts off Nellybear,he had them in a body shop to be prepared for spraying!!! when sanding them down they have taken a few chunks out of them.
Is there any way to fill these???
Has anybody experienced this before???
Any advice would be most appreciated.

I assume you mean Zender? (Fender make guitars )
If they are genuine ones you will need to use some plastic filler.

Thats the one! i new it was something like that cheers matey.

The zender skirts are plastic so it would be bloomin hard to take chunks out of them.
Im guessing they are a fibreglass replica skirt and the body shop has rubbed them too hard and gone through the resin outer coating.
If they have then they just need to apply some more resin to the holes and rub them down more carefully.

Yeah IIRC resin should fill it fine, think you can get it from Halfords but if you are geting them sprayed up by somewhere let them do it

Just take them along and ask for a quote or two from some places as they wil have to check them really well before fitting and if they give you a quote should honor it

Thanks for your help guys!!
I think they must be replicas Nellybear got them pretty cheap.