FC Performance Dyno League
I thought it might be interesting for everyone to see the results of live mapping, so I have compiled a FC Dyno League Table! Not every car I map is taken to the dyno for power figures, and I only recently started to take a copy of the results for each car so apologies for those that are missing. I should note all these cars were run on the exact same Dastek dyno so very good for comparing the various setups.

CLICK HERE FOR NEW DYNO LEAGUE TABLE

This Dyno table is a really good idea Leighton

I can wait to see my name in the next table

My project was temporarily discontinued since a few months because of the lack of money but i have now all the funds to finish it correctly

I want to run my car within a maximum of 2 or 3 months. I'm going to send you a pm with my full engine specifications and some last questions/advice needed before you begin the mapping part of the job

......had to be on top didn't ya pal !!

factually speaking of course !

if only my coop could hold 1.5 on the dyno, as it does on the road, we'll see

I'm just looking toward to be on that list!!

Interesting...

youve still got mine having you leighton?

Ninja

nice idea Leighton, now you just need to upload all the graphs into one place.

Founds a couple more including yours

Shall I dig out my dyno printouts Leighton?

I have your race fuel dyno chart, but nothing else. Can you email them to me?

Yes - I'll take a digital photo and send it to you.

We really need to get mine back on the dyno - when you did the mapping in summer, it was already 50psi down one one cylinder, and not brilliant on a couple of others

Took a little more boost though! You would have been near enough the same power if the limiter was extended by a few hundred rpms. More boost would swell the torque no question.

Leighton - my figures (from the April runs - we didn't dyno it in July - no point, as we knew it wasn't running right)

1.2 bar
385.6bhp @ 6555rpm, 317.2lb-ft @ 6204rpm

1.5 bar
388.9bhp @ 6496rpm, 350.8lb-ft @ 5076rpm

1.95 bar
400.8bhp @ 6365rpm, 363.1lb-ft @ 4936rpm

And just for the hell of it

1.9 bar on race fuel
420.8bhp @ 6606rpm, 358.0 lb-ft @ 5789rpm

its amazing..very good performançe...it is possible to know what this car ha???? paulwarner 20vturbo GT28RS 0.86 384bhp 328lbs 1.45bar ..

anymore additions to the table?

Disgraceful, you should be ashamed of yourself, Leighton. My competitive nature now dictates that I shall spend and spend in order to move as high as possible up the Coupe Premier League table....oh dear, this could be costly.

yey....i'm not last!

i doubt you or me will be on there too long sam - there's a few looking for increased power right now. i was going to uprate having already bought a pro alloy intercooler but cant stretch to a turbo yet, having been 15 mins from buying a good second hand one sunday....

I have a t28 waiting for a rebuild sat on my desk and my eye on a FMIC....please stop me

sell me the t28, that'll stop ya

It wasn't meant to be competitive

Of course I am more than willing to help anyone move up the ladder, plenty of options available

You would say that, you're at the top.

Isn't that where the tuner should be ?

Show off.

further expansion required methinks....

I intend to keep a top five position in that table - my car still hasn't been dyno'd with the new high-compression pistons - just waiting for the finances to get themsleves in order and it'll be time for some better injectors and a full remap

Maybe the table needs to be "equalised" by putting up the max figures at the same boost pressure, eg: 1.2 bar?

not sure about that but ambient temperature might tell a story for similar setups??

Who cares, I just want to be on that table!!

Coming to see you in January Flea!

I may need some advice before hand, speak soon!

nice table, oh and im the highest bhp GT28r hopefully that will take some beating.