No 2: Looks like an extension for vacuum gauge - balancing bike carbs

no 2 is it the carb needle

the third sorry to tell you are piston ring pliers

Well done Dave

http://media.photobucket.com/image/car%2...dwood036Sma.jpg
hi team just looking around for somthing challanging came across this any idears?

Errr.. you may want to rename it Dave

Is it a car half shaft ball race? lol

Second is a carb needle?

The second must be the pivot for the carburettor float then.

I wondered about the piston ring tool, those I have seen have been more of cylindrical type.

patch your the winner but does anybody know what car this is on and why would there be an arbarth embosed into the casting?

it's on a Fiat 131 Abarth Stradale (rally version of the Fiat 131) and you can read all about on Guy Croft's web site http://www.guy-croft.com/viewtopic.php?f=5&t=1909

Nice write-up on the Abarth, Dave. I like to see an enthusiast who can also write well about what's going on.

Any new photos?

the next 2...

1.

2.

(for image 2 i want to know what the hole unit is!!)

1. Jug holder

2. Lemon zest extractor

1. fancy air inlet on carburettor, eg: on a drag racer (nice pair though )

2. torque convertor thingummy for automatic gearbox?

dave G your a winner!

Patch your also a winner!! (first comment = WIN in my eyes!!)

NEXT ONES LOADED!

Brake piston and cv joint I think

1 is an upside down hydraulic tappet

2 must be a CV joint

WINNER!!!

im going for lunch, feel free to carry on guys!

mechanical fuel pump (upside down to confuse)

Stan’s bionic heart??

Dave's turn. Off a Lycoming aircraft engine, just to confuse.

Best I can do at the mo'

Rear arb spring bracket

is nobby right??

so whats this?

sounds good to me

catalitic converta