My mate is selling some 17" alloys from his Punto. 2000 reg I believe. They're quite a good price, does anyone know if they are a direct fit for my 20v Coupe?

not sure if this is the same but i had some alloys on my punto gt that my bro bought off me and put on his coupe 20vt

stud pattern should be the same, and so should the centre bore (as they are both fiat) but check if seller used spigot rings, if so then you will probably need them too.

the deciding factor for coupe fitment is usually the offset, but as you dont have brembos it wont be as crucial. (or spacers can be used if required)

you should also check required bolt length.


Ninja

allot of old fiats i have come across do use wobbly nuts & spacers to clear 0.2mm as there is more choice with 4x100 wheels...

i purchaced some wheels (twice) in the past for my coupe as was advertised as fiat fit & he had a picture of them on his car but when i tried i found i needed wobblys & spacers so ended up refurbing my 20vt alloys in a grey & will be selling the 17's on ebay (both sets)