On my VIS. Do you have to drill the holes in the pedals to mount them?

Yes and be sure to align them so the gap conforms to MOT standards.

Nah - space them how you want them, and take them off for the MOT. :-)

Dan, found this excert from an early post I did re. LE pedals, if you haven't already bought?

the difference between a blue Sparco sticker and a recessed imprint i.e. "Reflex" & "Grip" resectivly and I'm now sure that Grip pedals are a discontinued line, so when they're gone, they're gone! Plus the rubber plate behind the "Reflex" pedals, which has all the buttons on, would push out after a while leaving you with no rubber buttons visable/usable. Get youself a set on Ebay from a private buyer. They've taken a photo of the exact item so you can be sure they are the same as the LE originals with separate rubber studs and a recessed logo. I picked a brand new unfitted set for £20 inc p+p.

Hope this is of some use?

You've lost me Ross - I've a set of sparco pedals and I'm looking to fit them?

You have to drill holes, but its an easy job as the base plates are alloy.

Just make sure you leave enough room for the washers and nuts in the back, as it is easy to get too close to the pedal arms.

I've got these Sparco Piuma. Very easy to mount and looks awesome...

[image]http://sfk.ibk.se/forum/attachment.php?s=&postid=116477[/image]

Wasn't sure if you were looking to buy, or alraedy had

Already got a set knocking around Ross, so going to get the drill out soon.

Expect to see the "How do I fix drill holes in the floorpan" thread soon

They're the ones I've got to fit And already have in my 20vt!

BUT, you've only mounted them on one bolt? Don't they wiggle around?! Looks like they are

Good choice!
haha so you noticed that! well I took that pic when I test mounted them. They're know safely mounted with both bolts so don't worry mate