Scumrun qs again

Big breakers yard are sponsoring us (motorhog) went round today an stripped a coupe...of a fair few bits we needed

Just needed 4 20vt alloys but they only had 2...

We have access to almost every other manufacturers wheels...

So what other wheels can we have???
Looked at other 16" fiats but couldn't find a full set

Thanks

Is there a list on here for wheel types suitable???

Well, you need a pcd of 4 x 98, a central bore of 58.1mm and a approx an offset of 35, 37 or 42, depending on the coupe (i don't know)

If you fit aftermarket wheels you will need wobble bolts for 4 x 100pcd and you will need a spigot ring to allow the wheel to sit flush on the hub and check the offset, it is about 45 or so, then you can correct it with spacers

As Begbie said, You're looking for 4*98 pcd, 58,1mm center bore and 40-42mm ET.

FIAT: Tipo, Tempra, Bravo/Brava mk1, Punto mk1/2, Croma mk1...
ALFA: 145/146 and 155
LANCIA: Delta/Dedra, some Thema

Use the stock 20vt alloys on the front (as the rim spoke design clears the Brembos on 20vt) and non stock rims on th back (even with ET lower than 40)

I'm not Nigel