Anyone know where I can get one of these from? Torque Italia are not in a position to make any more of these until they have at least 10 firm interests (so far only about 4) and Pro Alloy have a design ready but massively busy on other stuff and I can't see anything ready promptly.

Need one asap as methanol/water reservoir for the Aquamist will go where the air filter is but that can't be moved until I get a straight induction pipe. No Aquamist will mean no point installing the GTEC 2 chip to take advantage of the ignition advance.

Frustrating...

Fishy Dave made his own straight induction kit using the pipes already on the car with exactly the same results as the stainless pipe, it might be worth sending him a PM to find out what he used.

i also made my own, all you need is some tubing i used 3" stainless so it was the same size as the RS inlet about 230mm long then you need 3 connections one 10mm and two 25mm if you are using a recir DV,or just a 10mm and a 25mm if you are using a atmos DV. The connections need to be about 25mm long and one 25mm and the 10mm need to be 100mm from one end of the tube with about a 60 degree angle between them the other 25mm needs to be about 50mm further along the tube inline with the other 25mm connection.

hope that helps ive just confused myself <img src="/forum/images/graemlins/laugh.gif" alt="" />

Kev

Heres the one I made up myself for £34.

Finished result

How long did that take to make?

The time it takes of putting the hoses and clips together <img src="/forum/images/graemlins/wink.gif" alt="" />
The alloy pipe came with the take-off already welded, with 3 interchangeable unions.

Where u get it from??

anyone know what are the connections necessary to be made to or from the straight induction pipe? a schematic diagram would be most helpful. thinking of getting one done up soon.
cheers
jeff

Pleb, you have PM