Hi

Are Alfa GTV V6 front hub carriers, and Brembos, a direct fit on a Coupe? Except for the 5 stud hub of course.

Yes!

Perfect fit!

I can also confirm that too

Awesome thanks

Is that with the 20VT also ?
Thankyou in advance.

Almost, but with 5 bolt flanges rather then 4. But you can just fit the flanges if you wanted.

Theres two different hubs fitted to a GTV I think you need the earlier one, as the later ones have the abs sensor in a different location.

Does that mean the CV/ABS ring is different too?

Yes as I found out to my cost

Later GTVs with EBD have an abs sensor which faces the rear of the wheel bearing, earlier cars have the ring on driveshaft like the Coupe set up I believe. I think it's around the year 2000 the changeover occured.

Hope this helps, I have a earlier hub in my garage if you need any photos to compare etc.

Some photos will be great thanks. Do you have photos of the wrong hubs too? I have found a set of 2001 GTV hubs locally.

Some poor photos from when I was doing it, the first photo shows the location of the sensor on the later cars.



Second one shows location for the GTV and I assume the Coupe



One thing I'm also aware of, is I'm pretty sure the GTV (V6 especially) has a slightly smaller diameter driveshaft than the 20VT, as when I bought a wheel bearing it was too small fot a 20VT.

Dam, the hubs I have found look like the later ones. Is there any way to use them? I guess the ABS wont work because the ring is smaller?

I wouldn't have thought so, the later system on GTVs is a lot more advanced than the earlier system, it's supposedly a EBD system.

OK cool. I want to get the calipers anyway as they are v low miles and in great shape. I assume thay are identical to the early ones?

They are te same calliper as the coupe and early GTAs. If you get the hubs with the outer CV joint I can't see no issues with wiring up the abs sensors to the coupes setup.

Im not sure what you mean there. Are you suggesting that If I get the later hubs and the CV's it will work on the Coupe? I can see that it will all bolt up on the car but will the output of the ABS sensor be compatible with a Coupe?

That's what I'm saying yes, if you can get the data sheet on the hal ring and count the notches and if they're the same it should work.