Have a squint at this?, anyone know anything about it on here?

http://www.ebay.co.uk/itm/fiat-coup...cles_CarParts_SM&hash=item4d0659061d

The description doesn't actually say it has a larger compressor on it, which you'd expect for a hybrid. It looks to be a standard refurbished unit with an uprated bearing and would probably have uprated seals so you could run a decat.

Ask what size the compressor trim is. If it's been changed it will say in the paperwork. The standard is 50 trim.

That's great thanks

That's what I thought exactly when I saw the standard-looking compressor side.

I'll ask him, but I think it's a standard unit just refurbed with the 360 bearing & staggered seals

Then again I'm no aftermarket turbo expert - hence the advice ask on here

All I'm used to is keep taking one off & putting it back on! Lol

Asked, awaiting reply.....

so cut back shafts allow faster spool up?

had a reply - 55 trim compressor (stated in paperwork). But he said it's now sold.

That'd make it a "superspool" which you can cross ref on fleas table.

It's still going on the bay though? If it's in the stated condition I'd say its worth between £250 - £300.

Worth a bid then?, as that would be in my budget or hang on for something else? I'll ask I'd he can post it anyway.

Where can Flea's table be found?

Would this require a FMIC? (or not essential but highly benefit one?)

In the FC performance section. You could fit with FMIC but on a standard car and remap would still see good gains.

Looks like hes sold it elsewhere!

indeed it has gone, wonder how much he accepted to end auction early, I bet it was less than £300!