if you use a hairdryer then you can mould the wrap easerly but you just have to take your time with it and not rush otherwise you end up with loads of little bubbles under the wrap , and of the wraps off ebay are ok just depends on how much you want to spend .

i was looking at this:

carbon vinyl on ebay

or this

what d'you think?

they both look like the stuff i have used so go for it , post some photos when you have done the dash

cool cheers bud

Did it stretch into the recess for the radio or is that a seperate piece

i used another peace of wrap in the recess for the radio , its very easy to match up and no one has noticed it yet .

Did you do the recess first or after? Also whats the centre console like to do

i did it after i had wrapped the front , its not bad but just take your time with it to get rid of any bubbles and it shouldn't take to long . i would have ago on something just to see how to do it and go from there .

How many pieces to do the centre console?

i did it with one peace apart from where the radio is

Sorry I mean the section where the handbrake is

i have left that and not bothered to do it

Probably a wise move

i have see a couple done and they look very patchy as it looks very hard to do .

If I have plenty left over I will give it a go, what about prep do you have to remove that rubber coating stuff?

yes you will have to remove it but i just used cheap nail varnish remover and a metal pot scourer and it comes of quite quick

Looks nice mate. There's some really nice blue c/f from a firm in the states that's got a glossy finish, not sure if its as flexible as the di-noc type vinyl though so might be better for flat surfaces?

http://www.decalfx.com/3d_carbon_fiber_blue_sheets.html

I did a few c/f bits on the last Saab and knocked up a few dash kits for some guys. Took ages but they looked pretty nice installed:
http://uksaabs.co.uk/UKS/viewtopic.php?f=24&t=71223&hilit=+Carbon+fibre

Also tried out a few different ones on ebay, got stung with a pretty large order as the stuff just bubbled and ended up in the bin or given to a mate for his track car project!
http://uksaabs.co.uk/UKS/viewtopic.php?f=1&t=74587&hilit=+Carbon+fibre

I've done my current dash with some dark metallic grey di-noc, but needs re-doing as its peeled in the center
http://uksaabs.co.uk/UKS/viewtopic.php?f=24&t=97536&hilit=+Carbon+fibre