My mate had his 20vt delievered to me as a non runner and to see if i can get her going again...
Well, after the usual checks it turned out to be the cam phase sensor..
No problems...
But the horror i found was a tad shocking..
this coupe is by far one the lucky ones...
It had a timing belt done 2 years ago...
Must of been a blind man that did the work..
So, the Aux belt was a lucky escape!!
Then, i found tipex.. didnt fill me with any joy.
So, lets start off with the Inlet as this was the better one of the and less shocking...
I worked this out to be 3 teeth out on the inlet..
Now the interesting part...
Never seen this...
6/7 teeth
left me speachless...
an overall pic
This was shocking to say the least,..
Any way, all timed up..
New belt on
All running and one happy friend!
This was such a mind fu* i went and borrwed 2 extra set's of locking tools from different mates around just incase mine where wrong...
Totaly amazed!
Just like to add, this is NOT a trader on the forum, its just a back street garage.
Any way!
How did this car run??? lol

p.s nice to be back on the forum again!