Hello!

I´m looking for a new injectors for my 16VT. I've been reading in the forum that many user put the siemens deka 60lbs/630cc. But when I look, there are two different models:

-Normal:


-Compact:


Which of these two is correct? Anyone have the reference number? Are they plug&play?

Thank you, best regards

Normal is what you will need.

You need to check on impedance of the injectors, think you will need high impedance, but I'm sure someone will be able to confirm.

Correct. EV1 or EV6 style injectors. High impedance.

Dynamic Flow Rate 2.5ms PW @ 100Hz (GAS): 20.2mg/pulse
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms
Turn off time: 0.85ms @ 600KPa
Factory Tollerance: +/-6 % Spray Pattern: Cone (4-Hole)
Grease supplied to lubricate o-rings prior to installation.

Product Specs

Injector Advertised Flow Rate (lbs/hr) 62.7 lbs./hr. @ 43.5
Injector Advertised Flow Rate (cc/min) 646 cc/min
Injector Impedance 11-18 ohms - High Impedence
Seat to Seat Height 60mm
Manifold O-Ring Outside Diameter 14mm
Fuel Rail O-Ring Outside Diameter 14

That's the ones I use!!

It must be the full length injector, and EV1 for a direct fit. The EV6 injector is not a direct fit for the original plug.

They are also not plug & play in terms injector cc, the ECU must be calibrated to the new size before fitting. The picture you listed is the 875cc injector.

http://www.cobaltss.net/forums/zz-performance-99/siemens-50-injectors-275384/

Look at second post down

Yes, forgot EV6 have an different plug