Hello

I was wondering if someone else in the forum is running one of these boost controllers if they could help out to as which hose from ebv goes where in the new solenoid, as i am not so good at reading the japanese instructions included

Finally found the english instructions, so now my problem is what hose is which This is from the manual:

Port 1: Connect to an uninterrupted intake manifold pressure
source after the throttle body such as a compressor bypass signal line using the 4mm hose ( Do not connect to the line that operates the fuel pressure regulator unless the suplemental instructions tell you so)
Port 2: Connect to a source of pressurized air such as
turbocharger compressor housing (discharge side) or compressor outlet pipe (before the intercooler)
Port 3: Connect to the port on the wastegate actuator

Can someone explain me which are these on EBV?

1. Boost Gauge
2. EBV red hose (IN)
3. EBV blue hose (OUT)

Somebody correct me if I'm wrong

Well, what is the 3rd hose in ebv for (the one on top)?
Does this just stay on the ebv along with the power plug or?
Hope someone else can confirm these things

sure I just plugged mine up. would check but car is away at moment.