Just recieved my greedy profec specb,and intend to fit it over easter

Just woundering if anyone has any settings for it,as it will be handy to just tweek them

Mods are

Gtir hybrid
Proalloy fmic,rad
sip
Gtech2
Turboback 2.7'bf,w/100cell cat
dv30

i intend to run ,lo=1bar,hi=1.2bar

Follow the handbook! All cars vary, however I'd guess the following would get you around 1 bar:

set = .55
gain = 10%
set gain = .85

However, best start off low and build, maybe try set at .3 or something like that to start just in case!

Am thinking about one of these too. Other than a chip for fuelling, is there any other mod I would need to accompany the Greddy? I have a 2.5" turbo back exhaust and a nice new turbo to rely on. What sort of bhp would I be looking at with the Greddy set to 1.2 bar and a Gtec? Thanks.

Thats good

Just want some base figures to start of on,then adjust it up or down

Start off the SET at 40/45. Mine is set at 50 with standard set up with just a gtech1 and K&N panel filter. Putting the other settings as low as can go.

Once you are happy with the SET, you can up the GAIN, start at 12/13 and gradually increase until you feel the boost levels start to fluctuate, then back the GAIN down a bit till you get a nice smooth boost level. My gain is set at 16/17 or something. As you increase the GAIN you may see a slight increase in the final boost pressure so you may have to down the SET a tad.

Finally you should set the SET GAIN. It should be slightly lower the final boost level you achieve ie if you set the SET and GAIN to give a boost level of 1.2 bar, set the SET GAIN to 1.15.

Greddys kick ass !!!

Once set up properly, it really does change the way the car drives.

I think it should be one of the first things everyone gets tuning wise anyway!!

Mark