Have you managed to fit your undertray with your FMIC ?

If so, which FMIC are you running ?

Thanks

i have my undertray on, im running with PA FMIC

omran

same here pa fmic with the under tray

You can use the undertray with the PA FMIC but you need to cut out the front section of the undertray. I don´t have any pic but maybe Highwayman has one or two.

there is a raised section on the undertray which needs to be cut out. about 3 inches deep and a little more than the length of the fmic itself. when cutting it, make sure you have a mask on and do it outside as it is made of some weird composite plastic which creates a fine dust when cutting. not good to get in your lungs.

EVO replica FMIC from Anew Digital - 008C model. Undertray is fitted but front bit cut out (with an angle grinder).

Ditto.

PA and undertray is on.

Undertray Fitted, you can see the front edge where the raised section used to be now has a cut out. The very front with the securing screws is still there so it all fastens up nicely.

Jimbo, what is that omp bar have you installed in your car?

I guess you missed this thread about half way down page 1

Thanks for the replies folks

do any of you with fmic find them noisey?

i have the Proto type single pass fmic, It whistless past 1 bar of boost, i will probably be selling it soon

are the evo & pro alloy noisey?

My PA one makes ghost noises when trundling around and banshee noises when booting it!

Great way of describing it.

Lol, i hope my new evo 9 makes the same sound, i'm going to miss it otherwise