Hi, i am getting the bits for my straight induction and fmic. I wondered if anyone knew the size of the turbo inlet (56 or 63mm), its a hybrid so its a standard size. My straight induction pipe is bigger then the turbo so need a reducer.

Thanks in advance.

Ash

I used 60mm from the turbo to sip (if your sip is tapered) and 75mm from sip to maf to cone.

If your sip is not tapered then you will need a reducer 75mm to 60mm I think.

Ive got blue silicone lengths of each (60mm and 75mm) - approx 7cm long each - £30.00 for all 3 + postage if you struggle to find any.

Thanks for the quick response. I have a 3" straight pipe which is the same size as the maf, so going to use a reducer from the 3" to the turbo 60mm. Should help it spool abit quicker

Have you got the hks dv aswell, sound really nice don't they.

Thanks Again

Ash

Standard turbo inlet is 2.5" (=63.5 mm).

I have ordered a 60mm to 76mm, hope it fits on the turbo then, i am sure i can force it on it will be going on for £25 lol.

It will, the fit is tight with the 60mm, little bit of washing up liquid on your finger round the inside lip of the tube and it slides on easily.