I have read the fitting guide in the "how to section" but have a question....

My 006 DV's 2 wide pipe sections are the same length unlike the one in the picture shown, does it matter which way the pipes are fitted? While i read the article it says that one way is louder than the other, is this the only effect?

*obiously the 3rd pipe is very slim with only one application possible.

Tom

It fits the same way as the std dv.

if you hold the valve so that the very small pipe nipple is pointing directly up, like in the top image in this link

http://www.bugone.co.uk/fiat/dump_valve.htm

then the large pipe pointing down is the one which is mounted directly into the large pipe like picture no 6 in the link.

I dont see how mounting it the other way will make much a huge difference, the air will still be travelling through the same gap.

HTH

the one opposite the very small hose, that one must come off the boost circuit. the one on the side is the recirculator, which goes back into the induction. if you put the two big ones the other way around i dont think it will work.

what colour spring does everyone use?

Yes, you're right sorry.

is this the same DV006 that is recommended ?

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=140156653368&ssPageName=STRK:MEWA:IT&ih=004

I have a yellow spring in mine.

no idea what spring, whatever it came with ..

prodigymotorsport on ebay did me one for £85 delivered .

Default spring is blue. I think it's a bit too firm. Might try the yellow but i don't want it to leak boost if i'm running 1.5Bar.