Not sure if Styling or Tuning is the right place, but...

I have a Nomad single pillar gauge pod thingummy with my Equus boost guage in (quite happy with the gauge).

Sooner or later I will get around to fitting the Apexi AVC-R so could do away with the boost gauge, but I also have a wideband lambda with AFR gauge to fit, and might get an Aquamist DDR3 guage, so that's up to 3 x 52mm gauges. I don't want to get rid of the clock and don't really want to drill the metal strip nor the black plastic covers under the metal strip, so I guess the A pillar is the place.

Anyone fitted 3 up the A pillar? What about just using a 3 x univeral fit single pod holders? Do 3 pods look and would I be better off with 2? Anyoine got a Nomad 2 pod thingummy I could buy, or swap with my single one?

Thoughts? Pics?

Maruisz does 3 pods for the left hand drives. Not seen them on the right hand drive models.

Sparkyman runs the dual pod and its pretty cool looking.

Ross

I have a dual pod and don't find them to get in the way except maybe when going round a tight right bend

don't think nomad do a triple pod!

What does the Aquamist gauge show?

Flowrate for the water injection system, plus indicators for low level, and a magic boost button watch the show it's either that or the DDS2 Nomad do the twin pod for a little over £70

I have a dual nomad pod on both sides Dave for exactly the reason you state.

I dont find they obscure vision at all. However try to put things on the left that you dont need to monitor all the time - like dds3

I have a dual pod with voltmeter and boost gauge and they dont get in the way. I was trying to find a triple pod so I could get an AFR gauge as well but they dont seem to exist for RHD. I might just remove the voltmeter.

If you do I would buy the voltmeter from you if it matches

It's a white dial face with black readings and a red needle