Hi
After a breakdown, on my coupe i have update some items.

Here are some pic
http://i66.photobucket.com/albums/h279/kepsus/HPIM3343.jpg
http://i66.photobucket.com/albums/h279/kepsus/HPIM3344.jpg
http://i66.photobucket.com/albums/h279/kepsus/HPIM3345.jpg
http://i66.photobucket.com/albums/h279/kepsus/HPIM3346.jpg

I would post my result asap it have been in the Dyno

ooooo shiney should be good once its all fitted...

yeah and this time i hpe this dual clutch plate can handle it

i'm sure you dont mean 190bhp for that kit!

290? 390?

just depends how big + you use :-)

I'd guess close to 490... (fly)

yeah i did re-think after its prob more like 490

hope you chance your cams too, otherwise your fly is around 340-350

ah cams, port head and so on was change in stage 1 :-)

ok, good to hear

Yep got my engine back from cylinder service, so hope to be ready to start her up, mid to last next week
engine
top

some other thing i just bought.

buttom ready, now for the head

Nice, but your missing a cylinder

looking good Kenneth, what intake side are you using? integrale? or kappa? - please take some photo's when you get that far and are fitting it back into the body

Just a little pic, when the head is on.. Sadley i did have some delay because of a broke headbolt.

But fix now, new bolts, new gasket..
pic1

nice, but what's the baby pram doing back there by the hydraulic lift

V.

lool you know family project

So what was the torque in the end you had to use?

rapid progress, you will show the rest of us up

this

1. step all srews with 40 Nm
2. step all srews with 60 Nm
3. step all srews with 90 Nm
4. step after 15 minutes release srew nr. 1 a bit and give en 90 Nm
keep working like this til bolt nr. 10

yeah a day again, with short time.. not always easy with job, wife ("#¤), and 2 kids...

Today's pic

Yep got my big (or really small) injectors today.. so hope to put inlet manifold on.
injectors

The only sadley things is i have to take my 400km old rc 550cc injectors out..

some pic of today..
change from pull to push
.....

and the engine
in the car

Ok i take some pic in the morning, the car are finish, just got my new injectors (again, and again)...

Now i am waiting to vas, help me with the ecu..

more pics
pic1
pic2
pic3

Ok it is running very well now, a BIG thanks to vas here, to bring the car back online..

Where did you bought that Flywheel, or is it custommade?

Greets / Emil

Nope i did buy it from www.scara73.it

Very nice, Kenneth. Are you going to get it rolling roaded now?

yeah, but fist i need to take the gearbox off and on (i do that saturday), and then need to drive 1000 km before i push it to hard.

ok, i am almost done with installing Full Throttle Shift
on my racelogic unit.

I gonna take some pic of the installation very soon.