Hi all, I have a AVC-R fitted to my car. But can't seem to regulate the boost to .6 bar. Would like to hold the boost down until I can get the car on the dyno. Just fitted a GT28r, blueflame system, SIP, tubular manifold and Pro Alloy FMIC. So don't want it to go bang.
Have checked if it's connected correctly (pipe wise) and it seems to be ok? the "com" is connected to the red pipe which goes to the actuator, the blue is connected to the "no" which goes to the turbine. The EBV is Tee'd into the vacum between the throttle body and the fuel rail regulator.
If I drive a lttle too hard I can easily see 1 bar, Any suggestions? Would like to know how to check whether the solinoid is working?

Cheers Tim

what happens if you set it to off

Either solenoid as they are common to go wrong or you have boost creep.

What is yor actuator set at? You wont be able to get less than that. If you want base boost (actuator pressure) just set the apexi to 'off.'

right, I'll try that

cheers all