I want to fine tune my greddy so that I can get solid boost with no creep or spike. It is fairly good but not quite right

I have a tubular manifold with 40mm external tial gate so the slight creep is not hardware related I don't think

the greddy settings are (profec E01)

For 1.0 bar

Set (duty) 44
Gain 20

and it creeps about half a PSI in the high revs which I am happy with. But it does spike at the start so I assume my "start set" is too high

For 1.25 bar

Set 56
Gain 20

But it actually creeps about 2 psi to 20psi (1.35bar)by red line

See the graph for the 2 boost lines



Am I right I have to drop the gain from 20 to a lower number to stop the creep from 1.25 to 1.35bar on the higher setting?, and if I wanted a 1.45bar setting I have worked out that would mean "set" value of 64 but anyone want to take a guess at gain setting for that.

Cheers

does some one have this setings for apexi avc-r???

with the gain i would lower it to about 15-18 probably better at 15 id say and that should be fine

i run 18 gain at 1.5bar (set by Flea)