Hi
I've finished fitting my Blitz I-color (i bought on ebay) yesterday.
1st thing 1st, i calibrated the speed & RPM... it works.
I've got a problem with the boost, i can't set the boost limit, i can't see the 4 channels, and i can't see the boost i'm running.

Check these pictures

pic 1
pic 2

As you can see ths boost is missing on the 2nd picture, and on the 1st one, i can't set the boost limits in the Calibration menu.

Do you have any idea of what's going wrong ?
I've fitted the solenoid on the turbo with the wires to the central unit, and fitted the t bone to get the boost pressure.

thank you

do a search for the manuel

that's what i did...

http://www.blitzpowerusa.com/techsupport/pdf/sbc_i-color.pdf

Hope this helps

Steve

as I v said, you don't have any problem...

the boost level choice is on another section on the blitz i color;
FUNCTION--->WARNING--->BST (for boost)

(ce que tu as ici, c'est juste l'afficheur des données; tu peux en choisir 2 ou 3 ou plus jusqu'à 6 sur le mien; tu as du effectivement faire une mauvaise manip et tu as fait disparaitre quelques lignes, mais c'est pas bien grave, c'est juste une petite manipe à faire pour revalider ton niveau de boost et te permettre de le voir afficher à nouveau sur le tableau)

More news
i've checked with Chr77176.
When i turn the ignition on, the screen display first "MMD Mode" in the top right hand corner whereas it shoulld be written "SBC ID mode"

i was asking myself if the unit don't display the boost => this unit is the MMD, but the MMD is an upgrade of the SBC ID, so it displays the same datas.

I'm asking myself this question : Should a possible cut on the harness (solenoid harness)not display the boost on the screen ?

"...whereas it should be written "SBC ID mode"..."

Sbc i wake up ...exactly

Well i checked again on the PDF, and it says : "Boost control functions will not be displayed if used as MMD I-color"

no idea guys ???