Any ideas of the make?

momo strut brace

Thanks! Any clue how easy they are to fit? Looks pretty simple.... (famous last words!)

Dead easy. You need to undo the bolts on top of the turrets with a 13mm socket. Position the brace over and then refit the bolts.

You need to make sure that the bolts are long enough and you need to be careful that you don't cross thread the bolt going in as the captive nuts on the top mounts are made of cheese.

Do you know which way round it goes, adjuster to the drivers or passenger side?

James you need to Hoover your floor

Ha Ha. You get plenty of help and advice on this forum

And if I could add;

You need to get some contrasting colours in there as it's all a bit....... "Grey".

A popular choise on here is purple

Bring it Saturday to Brooklands and I'll fit it or stand over you telling you what to do

Joe Minor (Jake) fitted mine at Brooklands last year....

He'll stand telling you what to do

I thought that is what Mario does?

The adjuster lives on the right hand side as you stand at the front.

You might have to remove the plastic engine loom tray that runs across the top of the O/S turret as well as pull the ABS maxifuse holder forward, they do fit but this design was meant for the 16v and 20v n/a models.

No thats what Nick does

Granted, the floor needs a hoover, but is it really my job? Come to think of it there's a pile of washing up in the kitchen too

As for the brace, i'll be swapping it with my omp one tomorrow, after a good polishing and maybe hoovering my carpet

Polished and fitted!

Looking good.

Puts your inlet plenum and suspension strut mounts to shame

They are on the list Jimbo!

Snap!

nice bonnet pull

My cable is in working order. Intermittent when I first got the car so put a cable on it. And so it remains.
Consider it insurance now. Better than a screwdriver any ways up!