just had a bit of a nightmare fitting my new skirts... i used tigerseal.. and that did pretty much nothing but make a mess and then it rained they lined up perfectly no gaps or anything but they just wouldnt stick.

i cleaned the surface before hand ..

how do i fit these little fccukers ? as im at my wits end

The genuine Zender skirts need 2 bolts through the front edge and 2 through the rear edge into the bodywork.

We then used panel seal along the top edge and located the bottom lugs to the underside of the car.

Kept each skirt pressed up against the side of the car for an hour with a piece of timber and hey presto, job done.

Neither skirt has moved since.

I think, the best is glue for car windscreens, for example Wurth..

Fitting diagram - http://www.autods.net/skirtsfit.jpg

humm screws

will have another crack tomorow thanks

I had the same problem, i used tiger seal and it took so long to go off, it didnt stick how i wanted it to.

i used tiger seal and duct tape to keep it in place,left over night solid as a rock

When I had mine I riveted the skirts on the filled over the rivets before spraying (The skirts had been sprayed prior to installation) Don't like glue much

http://img.photobucket.com/albums/v717/sp33d12/13072008183.jpg

done

screwed and glued lol

Looking alot better Blue20vt. Can i just ask, did yours have the lip on the inside, the bit you put your glue on possibly at the top on the inside, because my lip seemed to make fitting them so difficult, i even shaved off most of the lip on the second one with a stanley knife.

If you have any time could you take a shot of yours from the rear and front running down the side, so i can see how far yours stick out.

I fitted mine and thought they looked right, then i saw this pic of Dan_S car and thought they wernt sticking out as much as mine but i couldnt get them in any more than they are.

http://i82.photobucket.com/albums/j249/Dan_V6/DSC00012.jpg

http://i82.photobucket.com/albums/j249/Dan_V6/DSC00008.jpg

http://i82.photobucket.com/albums/j249/Dan_V6/DSC00016.jpg

ill try and get a pic of mine tomorrow and see if theres a difference.

Lol same as my purple side skirts you brought off me dan (Danirv), from that coupe i broke for the engine

I have got some pics of my side skirts, can anyne tell if there sticking out to much or if there about right

http://i270.photobucket.com/albums/jj112/DanirvCoupeTurbo/DSC00191.jpg

http://i270.photobucket.com/albums/jj112/DanirvCoupeTurbo/DSC00189.jpg

http://i270.photobucket.com/albums/jj112/DanirvCoupeTurbo/DSC00188.jpg

Look fine to me...

And me!

Thank you, i added the pics od Dan_S's car ^^ up that way, and just thought that mine were sticking out alot further, so just wanted to check feel bit better now he he he

look pretty much spot on to me