I have a stainless steel exhaust, it currently has an exit pipe that is rolled at the end and sticks out. I would like to change it to a slash cut exhaust and to make closer to the bumper (it sticks out too much).
Is it possible to get just the rear tip changed or will it need a new backbox ? anyone done something similar.
I have same issue, mine is a slash cut and I would prefer a rolled end.
I also have the issue of it sticking out too far.
I was looking about pulling the back box in a little if the mounts will allow, but seeing as I would like a different tail pipe I might cut the end off and weld a new one on.