exhaust question

Fiat Coupe Club UK

Fiat Coupe Forum

» Club Members only
Workshop manual

» Announced
Posting images

» Related sites
Main club site
fiatcoupe.net

Top Posters(All Time)

barnacle 33,794

stan 32,123

Theresa 23,349

PeteP 22,314

bockers 21,083

JimO 17,919

Nigel 17,387

Print Thread

exhaust question #992607 01/03/2010 17:30 01/03/2010 17:30
Joined: Dec 2005 Posts: 7,705 Harpenden S sugerbear OP Je suis un Coupé
sugerbear OP Je suis un Coupé S Joined: Dec 2005 Posts: 7,705 Harpenden	I have a stainless steel exhaust, it currently has an exit pipe that is rolled at the end and sticks out. I would like to change it to a slash cut exhaust and to make closer to the bumper (it sticks out too much). Is it possible to get just the rear tip changed or will it need a new backbox ? anyone done something similar. Last edited by sugerbear; 01/03/2010 17:31. How to make a startrek widget cable >> http://tinyurl.com/dyje6fy

Re: exhaust question [Re: sugerbear] #992610 01/03/2010 17:37 01/03/2010 17:37
Joined: Dec 2005 Posts: 10,747 N.E Scotland mattB Club member 6
mattB Club member 6 I AM a Coop Joined: Dec 2005 Posts: 10,747 N.E Scotland	Depends if it's part of the back box or if it's a tip clamped on I suppose as to how easy or otherwise it might be to change. Death-rattle-tastic

Re: exhaust question [Re: mattB] #992611 01/03/2010 17:40 01/03/2010 17:40
D DidCoop Unregistered
DidCoop Unregistered D	Might have to change the entire rear box and all depends what angle the box is at, if it's welded etc.

Re: exhaust question [Re: ] #992617 01/03/2010 17:50 01/03/2010 17:50
S samsite999 Unregistered
samsite999 Unregistered S	your probably looking at a back box change unless you would be happy with one of them bolt on tips you get from halfords

Re: exhaust question [Re: ] #992933 02/03/2010 01:58 02/03/2010 01:58
A anthrax Unregistered
anthrax Unregistered A	Cut the end off and sleeve the other end on , like Blueflame back box has.No no to bolt on tips.

Re: exhaust question [Re: sugerbear] #993390 02/03/2010 19:17 02/03/2010 19:17
B bridges Unregistered
bridges Unregistered B	Originally Posted by sugerbear I have a stainless steel exhaust, it currently has an exit pipe that is rolled at the end and sticks out. I would like to change it to a slash cut exhaust and to make closer to the bumper (it sticks out too much). Is it possible to get just the rear tip changed or will it need a new backbox ? anyone done something similar. I have same issue, mine is a slash cut and I would prefer a rolled end. I also have the issue of it sticking out too far. I was looking about pulling the back box in a little if the mounts will allow, but seeing as I would like a different tail pipe I might cut the end off and weld a new one on.